Demb Flip-It and Flash Diffuser

by Peter Kotsinadelis

The Demb bracket shown here with the Demb Flip-It! on the flash is set for vertical shooting.

April 01, 2011 — The first Demb product brought to the market was the “Flip-It!” flash reflector. It is a variable flash reflector that uses a heavy-duty hinge, allowing you to set the reflector at any angle. By doing this, you can then chose the best lighting and light output for any room or situation. Need softer light? Raise the panel. Want more lighting directed at your subject? Simply lower it.

The reflector base attaches to the flash using a rubber backed Velcro strap that stays in place when wrapped around the top part of the flash. The reflector we used in was the 4 x 4-inch “Big Flip-It!” The other available reflectors are the 2 ½ x 3-inch “Flip-It! Junior” and the 5 ¾ x 4 ¾-inch “Jumbo Flip-It!” All reflectors are interchangeable; so one base can be used with any reflector. Additionally, the big and jumbo sizes work well with flash units that have a parabolic reflector such as the Lumedyne, Quantum QFlash, or Sunpak 120J.

You Might Also Like



Two Doable and Affordable Ways You Can Capture 4K

Step into the 4K video era without breaking the bank—or your back. 

Read the Full Story »

Product Roundup: 10 Portable Hard Drives To Go When You Need To

An exploration of some solid state drives and hard disc drives to check out.Read the Full Story »

Software Review: Alien Skin Exposure 7

New functionality using film emulsion filters and more. 

Read the Full Story »


- ADVERTISEMENT -

- ADVERTISEMENT -

Tout VTS

- ADVERTISEMENT -

- ADVERTISEMENT -